ZyXEL omni.net LCD+M Instrukcja Użytkownika Pobierz pdf (Strona 112)

Technical Reference for ZyXEL omni.net series

9-4

Dialing Out for Internal Fax/Modem

Using the “M” command following the “ATD” will tell your omni.net LCD+M to automatically

switch calls to the internal fax/modem once dialing is complete.

Type: ATDM17146930762<enter>

Manually Switching Communication Modes

The manual switching functions will only be necessary if your communication software does not

allow you to change your dial-up string.

Conventional dialing commands: ATD, ATDT and ATDP, used by most existing communication

software, can be mapped onto one of the new dialing commands according to the AT&O setting as

follows:

AT Command Dial string it will map to

AT&O0 ATD, ATDT and ATDP are the same as ATDM

AT&O1 Auto-selection of 64kbps and 3.1 kHz on outgoing calls

AT&O2 ATD, ATDT and ATDP are the same as ATDI

AT&O3 ATD, ATDT and ATDP are the same as ATDA

Table 56. AT Command for Conventional dialing commands

The factory default is AT&O2. This means the modem will select ISDN data mode when you do

not specify which communication mode to use in your dial command (i.e. ATD or ATDT).

ATDMs

This command directs the modem to go on-line, dial according to the string entered and attempt to

establish a connection.

If +FCLASS=0 is selected, the modem will behave as a data modem and will attempt to connect to

another data modem. The modem will have up to the period of time specified by register S7 to wait

for a connect. If this time expires before the modem can connect, the modem will go on-hook with

the NO CARRIER response. This command will be aborted in progress upon receipt of any DTE

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 185 186

Brak uwag

ZyXEL omni.net LCD+M Instrukcja Użytkownika Strona 112