ZyXEL Communications Network Router NOT AVAILABLE Instrukcja Użytkownika Pobierz pdf (Strona 211)

Chapter 33 System

NXC CLI Reference Guide

211

33.5 Console Port Speed

This section shows you how to set the console port speed when you connect to the NXC via

the console port using a terminal emulation program. The following table describes the

console port commands.

You must use the configure terminal command to enter the

configuration mode before you can use these commands.

33.6 DNS Overview

DNS (Domain Name System) is for mapping a domain name to its corresponding IP address

and vice versa. The DNS server is extremely important because without it, you must know the

IP address of a machine before you can access it.

33.6.1 DNS Commands

The following table identifies the values required for many of these commands. Other input

values are discussed with the corresponding commands.

The following table describes the commands available for DNS. You must use the

configure

terminal

command to enter the configuration mode before you can use these commands.

Table 122 Command Summary: Console Port Speed

COMMAND DESCRIPTION

[no] console baud baud_rate Sets the speed of the console port. The

no command

resets the console port speed to the default

(

115200).

baud_rate: 9600, 19200, 38400, 57600 or 115200.

show console Displays console port speed.

Table 123 Input Values for General DNS Commands

LABEL DESCRIPTION

address_object The name of the IP address (group) object. You may use 1-31 alphanumeric

characters, underscores(

_), or dashes (-), but the first character cannot be a

number. This value is case-sensitive.

interface_name The name of the interface.

Ethernet interface: gex, x = 1 - N, where N equals the highest numbered

Ethernet interface for your NXC model.

VLAN interface: vlanx, x = 0 - 511.

Table 124 Command Summary: DNS

COMMAND DESCRIPTION

[no] ip dns server a-record fqdn w.x.y.z Sets an A record that specifies the mapping of a

fully qualified domain name (FQDN) to an IP

address. The no command deletes an A record.

ip dns server cache-flush Clears the DNS .

[no] ip dns server mx-record domain_name

{w.x.y.z|fqdn}

Sets a MX record that specifies a mail server that

is responsible for handling the mail for a

particular domain. The no command deletes a

MX record.

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 299 300

Komentarze do niniejszej Instrukcji

Brak uwag

ZyXEL Communications Network Router NOT AVAILABLE Instrukcja Użytkownika Strona 211

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie ZyXEL Communications Network Router NOT AVAILABLE